LAV-AT-G70 vs XC2KU050P
A comparison of the Lattice Avant-G LAV-AT-G70 and the AMD Kintex UltraScale+ Gen 2 XC2KU050P using the data from both vendors' selection guides.
Side-by-side specifications
| LAV-AT-G70 | XC2KU050P | |
|---|---|---|
| Vendor / family | Lattice Avant-G | AMD Kintex UltraScale+ Gen 2 |
| Logic (LUT4-equivalent) | 397,000 | 360,000 |
| LUTs as published | 397,000 LUT4 | 225,000 LUT6 |
| Vendor logic figure | 637,000 LC | 491,000 SLC |
| DSP | 1,800 18×18 multipliers | 1,872 DSP slices |
| Block RAM | 35.6 Mb | 17.7 Mb |
| Large RAM | — | 27 Mb |
| Max. user I/O | 554 | 516 |
| Transceivers | 28 × SERDES 12.5 Gb/s | 24 × GTY 32.75 Gb/s |
| Hard PCI Express | None | Gen4 x8 |
| Hard processor | None | None |
| Process | 16 nm | 16 nm |
| Configuration memory | SRAM | SRAM |
| Packages | 3 | 2 |
| Design tool | Lattice Radiant | AMD Vivado |
Highlighted values are higher. Logic is compared in LUT4 equivalents; see how FPGA vendors count logic.
Key differences
The LAV-AT-G70 has about 10% more logic capacity (397K vs 360K LUT4 equivalents).
They use different logic architectures: the LAV-AT-G70 is built from LUT4 and the XC2KU050P from LUT6, so the raw LUT counts (397K vs 225K) are not directly comparable.
For arithmetic, the XC2KU050P has 1,872 DSP slices against 1,800 18×18 multipliers on the LAV-AT-G70.
The XC2KU050P has more on-chip memory (44.7 Mb vs 35.6 Mb).
Both have transceivers: 28 at up to 12.5 Gb/s on the LAV-AT-G70 and 24 at up to 32.75 Gb/s on the XC2KU050P.
The LAV-AT-G70 is designed with Lattice Radiant and the XC2KU050P with AMD Vivado.
Full specifications
See the complete spec sheets with packages and grades: LAV-AT-G70 (Avant-G) and XC2KU050P (Kintex UltraScale+ Gen 2).