EP4SE820 vs LAV-AT-E70
A comparison of the Altera Stratix IV EP4SE820 and the Lattice Avant-E LAV-AT-E70 using the data from both vendors' selection guides.
Side-by-side specifications
| EP4SE820 | LAV-AT-E70 | |
|---|---|---|
| Vendor / family | Altera Stratix IV | Lattice Avant-E |
| LUTs as published | 325,220 ALMs | 397,000 LUT4 |
| LUT type | adaptive logic module: fracturable 8-input LUT (one 6-input or two independent 4-input functions) | 4-input look-up table |
| LUT4 equivalent (approx.) | ≈650,440 | ≈397,000 |
| CoreScore (SERV cores) | — | — |
| Vendor logic figure | 813,000 LE | 637,000 LC |
| DSP | 960 18×18 multipliers | 1,800 18×18 multipliers |
| Block RAM | 22.6 Mb | 35.6 Mb |
| Large RAM | — | — |
| Max. user I/O | 1,104 | 553 |
| Transceivers | None | None |
| Hard PCI Express | None | None |
| Hard processor | None | None |
| Process | 40 nm | 16 nm |
| Configuration memory | SRAM | SRAM |
| Packages | 3 | 4 |
| Design tool | Altera Quartus Prime | Lattice Radiant |
Highlighted values are higher. LUT counts are shown as published; the LUT4 equivalent is an approximation to compare different LUT types, see how FPGA vendors count logic. Add up to two more devices to this comparison.
Key differences
The EP4SE820 has about 64% more logic capacity (650K vs 397K LUT4 equivalents).
They use different logic architectures: the EP4SE820 is built from ALMs and the LAV-AT-E70 from LUT4, so the raw LUT counts (325K vs 397K) are not directly comparable.
For arithmetic, the LAV-AT-E70 has 1,800 18×18 multipliers against 960 18×18 multipliers on the EP4SE820.
The LAV-AT-E70 has more on-chip memory (35.6 Mb vs 22.6 Mb).
The EP4SE820 is designed with Altera Quartus Prime and the LAV-AT-E70 with Lattice Radiant.
Full specifications
See the complete spec sheets with packages and grades: EP4SE820 (Stratix IV) and LAV-AT-E70 (Avant-E).