FPGA & adaptive SoC databook · online editionRev. 2026.10

GW1NSR-4C vs M2S010

A comparison of the Gowin LittleBee GW1NSR-4C and the Microchip SmartFusion2 M2S010 using the data from both vendors' selection guides.

Side-by-side specifications

GW1NSR-4CM2S010
Vendor / familyGowin LittleBeeMicrochip SmartFusion2
LUTs as published4,608 LUT412,084 LUT4
LUT type4-input look-up table4-input look-up table
LUT4 equivalent (approx.)≈4,608≈12,084
CoreScore (SERV cores)——
Vendor logic figure—12,084 LE
DSP16 18×18 multipliers22 18×18 math blocks (MACC)
Block RAM0.2 Mb0.4 Mb
Large RAM——
Max. user I/O106233
TransceiversNone4 × SERDES 5 Gb/s
Hard PCI ExpressNoneGen2
Hard processor1× Cortex-M31× Arm Cortex-M3
Process55 nm65 nm
Configuration memoryEmbedded flashNon-volatile (flash)
Packages34
Design toolGowin EDAMicrochip Libero SoC

Highlighted values are higher. LUT counts are shown as published; the LUT4 equivalent is an approximation to compare different LUT types, see how FPGA vendors count logic. Add up to two more devices to this comparison.

Key differences

The M2S010 has about 162% more logic capacity (12.1K vs 4.6K LUT4 equivalents).

For arithmetic, the M2S010 has 22 18×18 math blocks (MACC) against 16 18×18 multipliers on the GW1NSR-4C.

The M2S010 has more on-chip memory (0.4 Mb vs 0.2 Mb).

Only the M2S010 has multi-gigabit transceivers (4 5 Gb/s).

Configuration memory: embedded flash on the GW1NSR-4C, non-volatile (flash) on the M2S010.

The GW1NSR-4C is designed with Gowin EDA and the M2S010 with Microchip Libero SoC.

Full specifications

See the complete spec sheets with packages and grades: GW1NSR-4C (LittleBee) and M2S010 (SmartFusion2).