GW3AT-6 vs LIF-MDF6000
A comparison of the Gowin Arora III GW3AT-6 and the Lattice CrossLinkPlus LIF-MDF6000 using the data from both vendors' selection guides.
Side-by-side specifications
| GW3AT-6 | LIF-MDF6000 | |
|---|---|---|
| Vendor / family | Gowin Arora III | Lattice CrossLinkPlus |
| LUTs as published | 6,912 LUT4 | 5,936 LUT4 |
| LUT type | 4-input look-up table | 4-input look-up table |
| LUT4 equivalent (approx.) | ≈6,912 | ≈5,936 |
| CoreScore (SERV cores) | — | — |
| Vendor logic figure | — | — |
| DSP | — DSP blocks | — 18×18 multipliers |
| Block RAM | 0.3 Mb | 0.2 Mb |
| Large RAM | — | — |
| Max. user I/O | 70 | 37 |
| Transceivers | 1 × SERDES 8.5 Gb/s | None |
| Hard PCI Express | None | None |
| Hard processor | None | None |
| Process | — | 40 nm |
| Configuration memory | SRAM | Internal flash |
| Packages | 0 | 2 |
| Design tool | Gowin EDA | Lattice Diamond |
Highlighted values are higher. LUT counts are shown as published; the LUT4 equivalent is an approximation to compare different LUT types, see how FPGA vendors count logic. Add up to two more devices to this comparison.
Key differences
The GW3AT-6 has about 16% more logic capacity (6.9K vs 5.9K LUT4 equivalents).
The GW3AT-6 has more on-chip memory (0.3 Mb vs 0.2 Mb).
Only the GW3AT-6 has multi-gigabit transceivers (1 8.5 Gb/s).
Configuration memory: sram on the GW3AT-6, internal flash on the LIF-MDF6000.
The GW3AT-6 is designed with Gowin EDA and the LIF-MDF6000 with Lattice Diamond.
Full specifications
See the complete spec sheets with packages and grades: GW3AT-6 (Arora III) and LIF-MDF6000 (CrossLinkPlus).