LAV-AT-G30 vs XCAU20P
A comparison of the Lattice Avant-G LAV-AT-G30 and the AMD Artix UltraScale+ XCAU20P using the data from both vendors' selection guides.
Side-by-side specifications
| LAV-AT-G30 | XCAU20P | |
|---|---|---|
| Vendor / family | Lattice Avant-G | AMD Artix UltraScale+ |
| Logic (LUT4-equivalent) | 163,000 | 174,400 |
| LUTs as published | 163,000 LUT4 | 109,000 LUT6 |
| Vendor logic figure | 262,000 LC | 238,000 SLC |
| DSP | 700 18×18 multipliers | 900 DSP slices |
| Block RAM | 14.4 Mb | 7 Mb |
| Large RAM | — | — |
| Max. user I/O | 298 | 228 |
| Transceivers | 12 × SERDES 12.5 Gb/s | 12 × GTY 32.75 Gb/s |
| Hard PCI Express | None | Gen3 x8 |
| Hard processor | None | None |
| Process | 16 nm | 16 nm |
| Configuration memory | SRAM | SRAM |
| Packages | 3 | 2 |
| Design tool | Lattice Radiant | AMD Vivado |
Highlighted values are higher. Logic is compared in LUT4 equivalents; see how FPGA vendors count logic.
Key differences
Both devices offer similar logic capacity: 163K and 174K LUT4 equivalents.
They use different logic architectures: the LAV-AT-G30 is built from LUT4 and the XCAU20P from LUT6, so the raw LUT counts (163K vs 109K) are not directly comparable.
For arithmetic, the XCAU20P has 900 DSP slices against 700 18×18 multipliers on the LAV-AT-G30.
The LAV-AT-G30 has more on-chip memory (14.4 Mb vs 7 Mb).
Both have transceivers: 12 at up to 12.5 Gb/s on the LAV-AT-G30 and 12 at up to 32.75 Gb/s on the XCAU20P.
The LAV-AT-G30 is designed with Lattice Radiant and the XCAU20P with AMD Vivado.
Full specifications
See the complete spec sheets with packages and grades: LAV-AT-G30 (Avant-G) and XCAU20P (Artix UltraScale+).